Use Miyuki Tila and Half Tila Beads in different colors to make endless variations of this bracelet!
Cut two strands of Amiet cord 24 inches long each. Knot the two strands together, leaving an 8-inch tail on the end.
Add a Miyuki opaque luster rose Tila bead, a Miyuki white Half Tila bead, a Miyuki orange Half Tila bead, a white Tila bead, a rose Tila bead, and then three TOHO Demi Round beads on each strand. Repeat this pattern twice, leaving off the TOHO Demi Round beads on the end.
Knot the cords together at the end of the beads to keep them in place.
Knot the ends of the cords together at each end of your bracelet to the size needed to fit over your hand. Add two TOHO Demi Round beads after the knot on each end and knot again. Trim the cord after the knots.
Make a sliding knot closure over the two ends of the bracelet using the Amiet cord. Knot the tails of the closure cord close to the sliding knot and trim. Secure with glue or a thread burner.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Use Miyuki Tila and Half Tila Beads in different colors to make endless variations of this bracelet!
Cut two strands of Amiet cord 24 inches long each. Knot the two strands together, leaving an 8-inch tail on the end.
Add a Miyuki opaque luster rose Tila bead, a Miyuki white Half Tila bead, a Miyuki orange Half Tila bead, a white Tila bead, a rose Tila bead, and then three TOHO Demi Round beads on each strand. Repeat this pattern twice, leaving off the TOHO Demi Round beads on the end.
Knot the cords together at the end of the beads to keep them in place.
Knot the ends of the cords together at each end of your bracelet to the size needed to fit over your hand. Add two TOHO Demi Round beads after the knot on each end and knot again. Trim the cord after the knots.
Make a sliding knot closure over the two ends of the bracelet using the Amiet cord. Knot the tails of the closure cord close to the sliding knot and trim. Secure with glue or a thread burner.