Raven's Journey Czech glass beads make a magical touch on these bracelets. Jessica created two variations with gold and silver accents because she loved these beads so much!
Gold Bracelet:
Cut a length of jewelry wire approximately 10 inches. Slide a crimp tube onto one end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add two crystal pearls to the wire and then add the following pattern:
Repeat this pattern 4 times, and then add a square spacer, a duckbill bead, a square spacer, and two pearls.
Add a crimp tube to the end of the bracelet, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Silver Bracelet:
Cut a length of jewelry wire approximately 10 inches. Slide a crimp tube onto one end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern four times and then add a pearl, a coiled spacer, a duckbill bead, a coiled spacer, and a pearl.
Add a crimp tube to the end of the bracelet, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Raven's Journey Czech glass beads make a magical touch on these bracelets. Jessica created two variations with gold and silver accents because she loved these beads so much!
Gold Bracelet:
Cut a length of jewelry wire approximately 10 inches. Slide a crimp tube onto one end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add two crystal pearls to the wire and then add the following pattern:
Repeat this pattern 4 times, and then add a square spacer, a duckbill bead, a square spacer, and two pearls.
Add a crimp tube to the end of the bracelet, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Silver Bracelet:
Cut a length of jewelry wire approximately 10 inches. Slide a crimp tube onto one end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern four times and then add a pearl, a coiled spacer, a duckbill bead, a coiled spacer, and a pearl.
Add a crimp tube to the end of the bracelet, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.