This bracelet set pairs the intense Eden Green pearl with fabulous bicones in Topaz, Tangerine AB 2x, and Light Siam AB 2x. As you can see, switching up the bicone colors and the bead caps used between the beads creates a whole new look for each bracelet pattern. The Eden Green pearls are part of Spring/Summer 2020. Check out all of the Innovations here.
Cut a length of jewelry wire approximately ten inches long. Slide a sterling silver 2x2mm crimp tube onto one end, followed by a sterling silver 4.60mm open jump ring attached to half of the TierraCast antique pewter heirloom toggle set. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern 12 times and then add a 4mm pearl to the end of the strand.
Repeat the steps for the bracelet above, using this bead pattern:
Repeat this pattern ten times, and then add a Bicone to the end of the strand.
,Repeat the steps for the bracelet above, using this bead pattern:
Repeat this pattern ten times and then add a Bicone to the end of the strand.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This bracelet set pairs the intense Eden Green pearl with fabulous bicones in Topaz, Tangerine AB 2x, and Light Siam AB 2x. As you can see, switching up the bicone colors and the bead caps used between the beads creates a whole new look for each bracelet pattern. The Eden Green pearls are part of Spring/Summer 2020. Check out all of the Innovations here.
Cut a length of jewelry wire approximately ten inches long. Slide a sterling silver 2x2mm crimp tube onto one end, followed by a sterling silver 4.60mm open jump ring attached to half of the TierraCast antique pewter heirloom toggle set. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern 12 times and then add a 4mm pearl to the end of the strand.
Repeat the steps for the bracelet above, using this bead pattern:
Repeat this pattern ten times, and then add a Bicone to the end of the strand.
,Repeat the steps for the bracelet above, using this bead pattern:
Repeat this pattern ten times and then add a Bicone to the end of the strand.