Dagger beads create fun dangling style in this earrings and bracelet set. Cynthia wire-wrapped the daggers onto fun Nunn Design hoops for the earrings and just incorporated them into the stringing pattern for the bracelet. Cynthia made this set during a Facebook Live Design Challenge. Watch her make these pieces and other designs here.
Cut a length of Rose Gold 24 gauge Artbeads Designer Wire approximately two feet long. Coil the end to one side of a Nunn Design antique copper-plated brass small oval hoop ear wire. Coil it around approximately five times to secure it to the earring.
Cut a length of jewelry wire approximately 11 inches long. Slide a TierraCast copper 2x2mm crimp bead onto the end, followed by a 6mm copper 20 gauge open jump ring attached to half of the 18x7mm copper-plated barrel magnetic clasp. Bring the wire back through the crimp bead and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern two times and then add three dagger beads.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Dagger beads create fun dangling style in this earrings and bracelet set. Cynthia wire-wrapped the daggers onto fun Nunn Design hoops for the earrings and just incorporated them into the stringing pattern for the bracelet. Cynthia made this set during a Facebook Live Design Challenge. Watch her make these pieces and other designs here.
Cut a length of Rose Gold 24 gauge Artbeads Designer Wire approximately two feet long. Coil the end to one side of a Nunn Design antique copper-plated brass small oval hoop ear wire. Coil it around approximately five times to secure it to the earring.
Cut a length of jewelry wire approximately 11 inches long. Slide a TierraCast copper 2x2mm crimp bead onto the end, followed by a 6mm copper 20 gauge open jump ring attached to half of the 18x7mm copper-plated barrel magnetic clasp. Bring the wire back through the crimp bead and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Repeat this pattern two times and then add three dagger beads.