Ingenue Necklace Tutorial

Layer the large brass heavy donut pendant with patina onto the brass filigree square wreath with patina embellishment using five-minute epoxy adhesive. Layer the brass fancy clamshell pendant with patina finish on the top of the donut pendant using adhesive, as well (make sure to cut the loop of the pendant off before gluing). Allow to dry.

Using Two-Part Epoxy Adhesive Video Tutorial

Cut a length of jewelry wire approximately 26 inches long. Slide a 14K/20 gold-filled 2x2mm crimp tube onto the end of the wire, followed by a 6mm 18g brass jump ring with patina finish attached to the loop component of the brass-plated Bali-style teardrop toggle clasp with patina finish. Bring the wire back through the crimp tube and crimp in place.

Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial

Add the following pattern to the wire:

• One Czech glass 6mm oxidized bronze clay round bead
• One Czech glass 8mm turquoise bronze Picasso fire-polished bead
• One TOHO 3/0 transparent-frosted teal round bead
• One 8mm fire-polished bead

Repeat this pattern five times.

Add the following pattern to the wire:

• One 6mm round
• One 8mm fire-polished bead
• One TierraCast brass oxide pewter botanical bead
• One 8mm fire-polished bead
• One 6mm round
• One 8mm fire-polished bead
• One TOHO 3/0 bead
• One 8mm fire-polished bead

Repeat this pattern once and then add a 6mm round.

Attach a jump ring to each of the two center openings at the top of your pendant. Connect these jump rings together using another jump ring. Then, link another jump ring to this jump ring. Slide your pendant onto the wire using the top jump ring. Depending on how you glued your patina focals together, you may only need to attach one jump ring to the center opening at the top of the pendant. In this case, you can just use that jump ring to add your pendant

Make a mirror image of the bead patterns from steps 3 and 4 on the other side of the pendant.

Add a crimp tube to the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the jump ring and crimp in place.

List of Components
TierraCast Brass Oxide Pewter Botanical Bead (BRO5828, qty 4)
Czech Glass 8mm Turquoise Bronze Picasso Fire-Polished Bead Strand (CFP-BT6313-8, qty 2)
TOHO 3/0 Transparent-Frosted Teal Round Bead 2.5-Inch Tube (TBRDT3-7BDF, qty 1)
Czech Glass 6mm Oxidized Bronze Clay Round Bead Strand (SCR-15768-6, qty 1)
Large Brass Heavy Donut Pendant with Patina (PEND1558, qty 1)
Brass Fancy Clamshell Pendant with Patina Finish (PEND-1108, qty 1)
Brass Filigree Square Wreath with Patina Embellishment (EMBMT-0673, qty 1)
14K/20 Gold-Filled 2x2mm Crimp Tube (GF-CRM2, qty 2)
Brass-Plated Bali-Style Teardrop Toggle Clasp with Patina Finish (CLASP-0960, qty 1)
6mm 18g Brass Jump Ring with Patina Finish (100pc) (FIND-2376, qty 1)