These Raven's Journey leaves are a beautiful way to dress up any design. We wire-wrapped them to a memory wire bracelet in this project.
Cut one coil of memory wire using memory wire shears. Make a simple loop at the end of the bracelet using the memory wire pliers.
Cut a length of 24 gauge Antique Copper Artbeads Designer Wire approximately 3-4 feet long. Coil the end of the wire at the end of your bracelet near the simple loop. Coil several times to secure the wire.
Add a Czech glass leaf bead to the wire and pull close and tight to the memory wire. Coil the Artbeads Designer wire around the memory wire bracelet again to secure the leaf in place. Make about three coils.
With the wire coming from the front of the bracelet, add a fire-polished bead to the wire. Pull close and tight to the bracelet and coil the wire around the bracelet. Coil three times.
Add another leaf in the same manner as before, this time making sure the leaf is pointed in the opposite direction of the last leaf you added. Then, add another fire-polished bead.
Repeat steps 3-5 for the length of the bracelet, until there is only about an inch or so left of the wire. When you get close to the end of the wire, make a simple loop at the end of the memory wire and then finish your Artbeads Designer wire by coiling it around the end of the bracelet.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
These Raven's Journey leaves are a beautiful way to dress up any design. We wire-wrapped them to a memory wire bracelet in this project.
Cut one coil of memory wire using memory wire shears. Make a simple loop at the end of the bracelet using the memory wire pliers.
Cut a length of 24 gauge Antique Copper Artbeads Designer Wire approximately 3-4 feet long. Coil the end of the wire at the end of your bracelet near the simple loop. Coil several times to secure the wire.
Add a Czech glass leaf bead to the wire and pull close and tight to the memory wire. Coil the Artbeads Designer wire around the memory wire bracelet again to secure the leaf in place. Make about three coils.
With the wire coming from the front of the bracelet, add a fire-polished bead to the wire. Pull close and tight to the bracelet and coil the wire around the bracelet. Coil three times.
Add another leaf in the same manner as before, this time making sure the leaf is pointed in the opposite direction of the last leaf you added. Then, add another fire-polished bead.
Repeat steps 3-5 for the length of the bracelet, until there is only about an inch or so left of the wire. When you get close to the end of the wire, make a simple loop at the end of the memory wire and then finish your Artbeads Designer wire by coiling it around the end of the bracelet.