Raven's Journey Czech glass bead strands come together to create a beautiful bracelet for the holidays!
Cut a length of jewelry wire approximately 10 inches long. Add a crimp to one end of the wire, followed by a jump ring attached to one half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add a brown microspacer to the strand, followed by a burnt orange microspacer. Then, add the following pattern to the wire:
Add 1 brown microspacer, 1 wild rose bead, and 1 brown microspacer to the center of your bead pattern. Then, make a mirror image of the entire bead pattern from the previous step on the other side of these center beads.
Add a crimp tube to the end of the wire, followed by a jump ring attached to the other half of the toggle clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimps on each end of the bracelet with a crimp cover for each.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Raven's Journey Czech glass bead strands come together to create a beautiful bracelet for the holidays!
Cut a length of jewelry wire approximately 10 inches long. Add a crimp to one end of the wire, followed by a jump ring attached to one half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add a brown microspacer to the strand, followed by a burnt orange microspacer. Then, add the following pattern to the wire:
Add 1 brown microspacer, 1 wild rose bead, and 1 brown microspacer to the center of your bead pattern. Then, make a mirror image of the entire bead pattern from the previous step on the other side of these center beads.
Add a crimp tube to the end of the wire, followed by a jump ring attached to the other half of the toggle clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimps on each end of the bracelet with a crimp cover for each.