You can showcase any charm at the center of this bracelet, whether it's a zodiac charm or another charm that makes a personalized statement.
Cut a length of jewelry wire approximately 7 inches long. Slide a crimp tube onto the end of the wire. Add a jump ring attached to the top ring on one side of the tube clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add the following pattern to the wire:
Slide a crimp tube onto the end of the wire, followed by a sparkle jump ring. Bring the wire back through the crimp tube and crimp in place. Attach the sparkle jump ring to the Nunn Design hoop.
Cut a length of jewelry wire approximately 7 inches long. Slide a crimp tube onto the end of the wire. Add a jump ring attached to the bottom ring of the tube clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Slide a crimp tube onto the end of the wire, followed by a sparkle jump ring. Bring the wire back through the crimp tube and crimp in place. Attach the sparkle jump ring to the Nunn Design hoop, below the first one.
Repeat these steps to make the beaded strands for the other side of the bracelet. Use the other half of the tube clasp. Make sure to add the remaining sterling silver charm between the two pink round beads on the yellow strand and don't add a sterling silver charm to the blue strand.
Add the Gemini charm to the center of the Nunn Design hoop between the beaded strands using a sparkle jump ring.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
You can showcase any charm at the center of this bracelet, whether it's a zodiac charm or another charm that makes a personalized statement.
Cut a length of jewelry wire approximately 7 inches long. Slide a crimp tube onto the end of the wire. Add a jump ring attached to the top ring on one side of the tube clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add the following pattern to the wire:
Slide a crimp tube onto the end of the wire, followed by a sparkle jump ring. Bring the wire back through the crimp tube and crimp in place. Attach the sparkle jump ring to the Nunn Design hoop.
Cut a length of jewelry wire approximately 7 inches long. Slide a crimp tube onto the end of the wire. Add a jump ring attached to the bottom ring of the tube clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Slide a crimp tube onto the end of the wire, followed by a sparkle jump ring. Bring the wire back through the crimp tube and crimp in place. Attach the sparkle jump ring to the Nunn Design hoop, below the first one.
Repeat these steps to make the beaded strands for the other side of the bracelet. Use the other half of the tube clasp. Make sure to add the remaining sterling silver charm between the two pink round beads on the yellow strand and don't add a sterling silver charm to the blue strand.
Add the Gemini charm to the center of the Nunn Design hoop between the beaded strands using a sparkle jump ring.
