Wire wrapped beads surrounding the delightful TierraCast Succulent Charm make a gorgeous pendant! Try different gemstones, Czech Fire Polish beads, or seed beads for variation. Find PDF Instructions for this design here.
Cut one 20" piece of craft wire.
Anchor the wire to the top loop of the teardrop by threading one end through loop about 1", then wrapping long end around and through loop twice and pulling wire snugly. Do not trim tail yet so you can hold the wire as you wrap.
Begin to lash on the beads by stringing one faceted spacer onto wire and sliding it down so it sits at outside edge of teardrop. Holding on to the bead to keep it in place wrap wire twice around teardrop right next to bead. Use flat nose pliers to gently twist the bead if needed so that bead hole is in line with outside edge of teardrop.
Repeat Step 3 with one gemstone bead.
Repeat Steps 3-4 eleven times, keeping beads and wire tucked close to each other.
Lash on final faceted spacer, followed by two wraps inside loop of teardrop ending with wire extending from inside loop. Trim wire close to teardrop.
Trim wire end from Step 1 as in Step 6.
Open one jump ring and attach to loop on the inside of the teardrop (Use awl or T-pin to make space if the wire wrapping is in the way). Before closing attach succulent charm. Close jump ring.
Open a second jump ring and attach to loop on the outside of the teardrop. Before closing attach loop of bail. Close jump ring.
Thread chain through bail.
Open one jump ring and attach to one end of chain. Before closing attach clasp ring. Close jump ring.
Repeat Step 11 at other side to attach clasp bar.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Wire wrapped beads surrounding the delightful TierraCast Succulent Charm make a gorgeous pendant! Try different gemstones, Czech Fire Polish beads, or seed beads for variation. Find PDF Instructions for this design here.
Cut one 20" piece of craft wire.
Anchor the wire to the top loop of the teardrop by threading one end through loop about 1", then wrapping long end around and through loop twice and pulling wire snugly. Do not trim tail yet so you can hold the wire as you wrap.
Begin to lash on the beads by stringing one faceted spacer onto wire and sliding it down so it sits at outside edge of teardrop. Holding on to the bead to keep it in place wrap wire twice around teardrop right next to bead. Use flat nose pliers to gently twist the bead if needed so that bead hole is in line with outside edge of teardrop.
Repeat Step 3 with one gemstone bead.
Repeat Steps 3-4 eleven times, keeping beads and wire tucked close to each other.
Lash on final faceted spacer, followed by two wraps inside loop of teardrop ending with wire extending from inside loop. Trim wire close to teardrop.
Trim wire end from Step 1 as in Step 6.
Open one jump ring and attach to loop on the inside of the teardrop (Use awl or T-pin to make space if the wire wrapping is in the way). Before closing attach succulent charm. Close jump ring.
Open a second jump ring and attach to loop on the outside of the teardrop. Before closing attach loop of bail. Close jump ring.
Thread chain through bail.
Open one jump ring and attach to one end of chain. Before closing attach clasp ring. Close jump ring.
Repeat Step 11 at other side to attach clasp bar.