This necklace features fun summer colors! Watch Becky make this necklace in our video.
Add a drop bead from the Safari Green mix to a head pin and make a wrapped loop at the top.
Add a pink fire-polished bead to an eye pin, followed by a butter jasper bead, and a jonquil bicone. Make a wrapped loop at the top of the beads.
Attach the drop dangle to the simple loop at the bottom of the pink bead. Then, attach the beaded dangle to the loop at the bottom of the Luna Moth pendant using a jump ring. Add a jump ring to each hole on the wings of the Luna Moth.
Cut a length of jewelry wire approximately 12 inches. Slide a crimp tube onto the wire and then bring the wire through a jump ring on one side of the luna moth. Bring the wire back through the crimp tube and crimp in place. Repeat this step on the other side of the luna moth.
Add the following pattern to the wire:
Repeat this bead pattern on the wire on the other side of the necklace.
Add a crimp tube to the end of the wire, followed by a jump ring attached to half of the toggle clasp. Bring the wire back through the crimp tube and crimp in place. Add crimp covers to your crimp tubes if you wish. Repeat this step on the other side of the necklace.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This necklace features fun summer colors! Watch Becky make this necklace in our video.
Add a drop bead from the Safari Green mix to a head pin and make a wrapped loop at the top.
Add a pink fire-polished bead to an eye pin, followed by a butter jasper bead, and a jonquil bicone. Make a wrapped loop at the top of the beads.
Attach the drop dangle to the simple loop at the bottom of the pink bead. Then, attach the beaded dangle to the loop at the bottom of the Luna Moth pendant using a jump ring. Add a jump ring to each hole on the wings of the Luna Moth.
Cut a length of jewelry wire approximately 12 inches. Slide a crimp tube onto the wire and then bring the wire through a jump ring on one side of the luna moth. Bring the wire back through the crimp tube and crimp in place. Repeat this step on the other side of the luna moth.
Add the following pattern to the wire:
Repeat this bead pattern on the wire on the other side of the necklace.
Add a crimp tube to the end of the wire, followed by a jump ring attached to half of the toggle clasp. Bring the wire back through the crimp tube and crimp in place. Add crimp covers to your crimp tubes if you wish. Repeat this step on the other side of the necklace.