Create a classic look in just minutes with this necklace project.
Cut a length of leather approximately 20 inches.
Add the Artbeads sterling silver spiral link to the center of the leather using a 4.60mm jump ring. Attach the Artbeads sterling silver small ring link to the bottom of the spiral link using a 4.60mm jump ring. Attach the Artbeads sterling silver circle in circle pendant to the bottom of the ring link using a 4.60mm jump ring.
Attach the 6.10mm jump ring to the lobster clasp. Add one end of the leather through the jump ring.
Cut a length of Artbeads Designer Wire 2-inches long. Fold the end of the leather down around the jump ring and coil the wire around the ends of the loop made with the leather to secure it in place. Coil around about 6 times. Trim the wire ends and trim any excess leather.
Wire-Wrapped Cord Ends Tutorial
Wire-Wrapped Leather Ends Video Tutorial
Repeat step 4 for the other end of the leather. Don't add anything to this leather loop - it will be the loop to attach your clasp to secure the necklace.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Create a classic look in just minutes with this necklace project.
Cut a length of leather approximately 20 inches.
Add the Artbeads sterling silver spiral link to the center of the leather using a 4.60mm jump ring. Attach the Artbeads sterling silver small ring link to the bottom of the spiral link using a 4.60mm jump ring. Attach the Artbeads sterling silver circle in circle pendant to the bottom of the ring link using a 4.60mm jump ring.
Attach the 6.10mm jump ring to the lobster clasp. Add one end of the leather through the jump ring.
Cut a length of Artbeads Designer Wire 2-inches long. Fold the end of the leather down around the jump ring and coil the wire around the ends of the loop made with the leather to secure it in place. Coil around about 6 times. Trim the wire ends and trim any excess leather.
Wire-Wrapped Cord Ends Tutorial
Wire-Wrapped Leather Ends Video Tutorial
Repeat step 4 for the other end of the leather. Don't add anything to this leather loop - it will be the loop to attach your clasp to secure the necklace.
