The textures and colors of the Raven's Journey Czech glass beads in this jewelry set are perfect for the ocean theme.
Earrings:
Attach a TierraCast sand dollar charm to the loop of an eye pin using a sparkle jump ring.
Add a TierraCast ivy bead cap to the eye pin, followed by a Czech glass Saturn bead, a TierraCast nugget spacer, and a Czech glass rose rondelle bead. Make a simple loop at the top of the beads.
Attach an ear wire to the loop at the top of the eye pin using a sparkle jump ring.
Repeat these steps to make the other earring.
Bracelet:
Cut a length of jewelry wire approximately 10 inches. Slide a crimp tube onto the end of the wire, followed by a small jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern 5 times, leaving off the last gold nugget spacer.
Slide a crimp tube onto the end of the bracelet, followed by a small jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
The textures and colors of the Raven's Journey Czech glass beads in this jewelry set are perfect for the ocean theme.
Earrings:
Attach a TierraCast sand dollar charm to the loop of an eye pin using a sparkle jump ring.
Add a TierraCast ivy bead cap to the eye pin, followed by a Czech glass Saturn bead, a TierraCast nugget spacer, and a Czech glass rose rondelle bead. Make a simple loop at the top of the beads.
Attach an ear wire to the loop at the top of the eye pin using a sparkle jump ring.
Repeat these steps to make the other earring.
Bracelet:
Cut a length of jewelry wire approximately 10 inches. Slide a crimp tube onto the end of the wire, followed by a small jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern 5 times, leaving off the last gold nugget spacer.
Slide a crimp tube onto the end of the bracelet, followed by a small jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.