A TierraCast toggle clasp makes a beautiful focal for this necklace, thanks to the detailed design and openings for adding dangles.
Cut a length of jewelry wire approximately 28 inches long. Slide a crimp tube onto one end and then add half of the TierraCast Temple clasp set. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern 12 times, and then add a small bicone, a small faceted round, a Demi Round, a 6mm bicone, a Demi Round, a small faceted round, and a small bicone.
Slide a crimp tube onto the end of the wire, followed by the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add a 6mm Pacific Opal Shimmer bicone to a head pin and make a wrapped loop. Repeat with the 5mm Chrysolite Opal Shimmer bicone and your last 4mm Chrysolite Opal Shimmer bicone.
Attach the large pear pendant to the center loop on the toggle component using a large jump ring. Add the 6mm bicone dangle to the large jump ring using a smaller jump ring.
Add the small pear pendant to the loop to the right of the center loop using a large jump ring. Add the 5mm bicone dangle to the front of the pear pendant on the large jump ring using a smaller jump ring. Add the 4mm bicone dangle to the back of the pendant in the same manner.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
A TierraCast toggle clasp makes a beautiful focal for this necklace, thanks to the detailed design and openings for adding dangles.
Cut a length of jewelry wire approximately 28 inches long. Slide a crimp tube onto one end and then add half of the TierraCast Temple clasp set. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern 12 times, and then add a small bicone, a small faceted round, a Demi Round, a 6mm bicone, a Demi Round, a small faceted round, and a small bicone.
Slide a crimp tube onto the end of the wire, followed by the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add a 6mm Pacific Opal Shimmer bicone to a head pin and make a wrapped loop. Repeat with the 5mm Chrysolite Opal Shimmer bicone and your last 4mm Chrysolite Opal Shimmer bicone.
Attach the large pear pendant to the center loop on the toggle component using a large jump ring. Add the 6mm bicone dangle to the large jump ring using a smaller jump ring.
Add the small pear pendant to the loop to the right of the center loop using a large jump ring. Add the 5mm bicone dangle to the front of the pear pendant on the large jump ring using a smaller jump ring. Add the 4mm bicone dangle to the back of the pendant in the same manner.
