Artbeads Designer Series findings in sterling silver contrast beautifully with matte black chain!
Attach the sterling silver small five-petal flower charm to the inside of the sterling silver large ring with flower pendant using an 8mm jump ring.
Cut a length of 4mm rolo chain approximately 3 1/4 inches long. Attach the flower pendant to the center of the chain using a 4mm black jump ring.
Attach the sterling silver large branch and leaves link to one end of the chain using a 4mm jump ring. Attach the sterling silver three flower curved link to the other end of the chain using another 4mm jump ring.
Cut a 6-inch length of smooth flat cable chain and attach it to the silver link at one end of the necklace using a 6mm jump ring. Repeat on the other side of the necklace.
Attach each half of the toggle clasp to each end of the necklace using a 6mm jump ring for each.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Artbeads Designer Series findings in sterling silver contrast beautifully with matte black chain!
Attach the sterling silver small five-petal flower charm to the inside of the sterling silver large ring with flower pendant using an 8mm jump ring.
Cut a length of 4mm rolo chain approximately 3 1/4 inches long. Attach the flower pendant to the center of the chain using a 4mm black jump ring.
Attach the sterling silver large branch and leaves link to one end of the chain using a 4mm jump ring. Attach the sterling silver three flower curved link to the other end of the chain using another 4mm jump ring.
Cut a 6-inch length of smooth flat cable chain and attach it to the silver link at one end of the necklace using a 6mm jump ring. Repeat on the other side of the necklace.
Attach each half of the toggle clasp to each end of the necklace using a 6mm jump ring for each.