A gorgeous Gardanne Beads enameled pendant is showcased perfectly in this necklace.
Attach the Gardanne Beads wing pendant to the center loop of the patina pendant using a jump ring. Attach a jump ring to each of the remaining two loops on the patina pendant.
Cut a length of jewelry wire approximately 19 inches long. Slide a crimp tube onto the end and then bring the wire through a jump ring on one side of your patina pendant. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add the following pattern to the wire:
Repeat this pattern three times, leaving off the last seed bead, Wild Rose, and seed bead.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
A gorgeous Gardanne Beads enameled pendant is showcased perfectly in this necklace.
Attach the Gardanne Beads wing pendant to the center loop of the patina pendant using a jump ring. Attach a jump ring to each of the remaining two loops on the patina pendant.
Cut a length of jewelry wire approximately 19 inches long. Slide a crimp tube onto the end and then bring the wire through a jump ring on one side of your patina pendant. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add the following pattern to the wire:
Repeat this pattern three times, leaving off the last seed bead, Wild Rose, and seed bead.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.