Create something special with earthy gemstone colors. Cheri used Dakota Stones crazy lace agate beads in natural colors to perfectly match the pendant at the center of her necklace.
Cut a length of jewelry wire approximately 24 inches. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add the following pattern to the wire:
Add the following pattern to the wire:
Repeat this pattern twice, leaving off the last 4mm faceted round bead.
Add the mother of pearl pendant to the wire using the pinch bail. Then, make a mirror image of the bead patterns from steps 2 and 3 on the other side of the pendant.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Create something special with earthy gemstone colors. Cheri used Dakota Stones crazy lace agate beads in natural colors to perfectly match the pendant at the center of her necklace.
Cut a length of jewelry wire approximately 24 inches. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add the following pattern to the wire:
Add the following pattern to the wire:
Repeat this pattern twice, leaving off the last 4mm faceted round bead.
Add the mother of pearl pendant to the wire using the pinch bail. Then, make a mirror image of the bead patterns from steps 2 and 3 on the other side of the pendant.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.