You can make lots of beautiful jewelry with Jesse James Beads! We used the Flamingo Beach Mix to make this necklace, our Let's Go Party Earrings and the Let's Go Party Bracelet.
Cut a length of jewelry wire approximately 8-10 inches long.
Add the flamingo pendant to the bail from the chain set using a jump ring. Slide it onto the center of the jewelry wire.
Attach a jump ring from the chain set to a tassel from the bead mix. Repeat three times.
Add a pink cat’s eye bead to each side of your pendant, followed by a tassel, a hot pink bead, a flat flower, a pink rondelle, a flat flower, a tassel, and a cat’s eye bead.
Add a crimp tube to one end of your wire, followed by a jump ring. Bring the wire back through the crimp tube and crimp in place. Repeat on the other end of the jewelry wire.
Cut a length of chain approximately 8 inches long. Attach to the jump ring at one end of your necklace. Repeat for the other side of the necklace.
Attach a clasp from the chain set to one end of the necklace using a jump ring.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
The Flamingo Beach mix is so fun to use and I was instantly inspired to make this necklace!
You can make lots of beautiful jewelry with Jesse James Beads! We used the Flamingo Beach Mix to make this necklace, our Let's Go Party Earrings and the Let's Go Party Bracelet.
Cut a length of jewelry wire approximately 8-10 inches long.
Add the flamingo pendant to the bail from the chain set using a jump ring. Slide it onto the center of the jewelry wire.
Attach a jump ring from the chain set to a tassel from the bead mix. Repeat three times.
Add a pink cat’s eye bead to each side of your pendant, followed by a tassel, a hot pink bead, a flat flower, a pink rondelle, a flat flower, a tassel, and a cat’s eye bead.
Add a crimp tube to one end of your wire, followed by a jump ring. Bring the wire back through the crimp tube and crimp in place. Repeat on the other end of the jewelry wire.
Cut a length of chain approximately 8 inches long. Attach to the jump ring at one end of your necklace. Repeat for the other side of the necklace.
Attach a clasp from the chain set to one end of the necklace using a jump ring.
The Flamingo Beach mix is so fun to use and I was instantly inspired to make this necklace!