Gardanne Beads pendants are so inspiring thanks to the vibrant enameled colors and designs. It's so easy to start creating amazing jewelry with these pendants as the start.
Cut a length of jewelry wire approximately 19 inches long. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the toggle loop. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add three Czech glass round beads to the wire and then add the following pattern:
Repeat this pattern 4 times, leaving off the last 4 round beads in the sequence.
Add the Gardanne Beads pendant to the wire using a jump ring. Then, make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the wire, followed by the bar component of the toggle clasp (a jump ring should already be attached). Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Gardanne Beads pendants are so inspiring thanks to the vibrant enameled colors and designs. It's so easy to start creating amazing jewelry with these pendants as the start.
Cut a length of jewelry wire approximately 19 inches long. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the toggle loop. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add three Czech glass round beads to the wire and then add the following pattern:
Repeat this pattern 4 times, leaving off the last 4 round beads in the sequence.
Add the Gardanne Beads pendant to the wire using a jump ring. Then, make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the wire, followed by the bar component of the toggle clasp (a jump ring should already be attached). Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.