These adorable earrings feature a sweet teddy bear bead by TierraCast with its arms stretched out, ready to give a hug. On either side of the bear are lovely PRESTIGE Crystal beads in a rosy pink color.
Please note we have updated this project using PRESTIGE Crystal bicone beads instead of the beads pictured and a slightly smaller earring hook. You can use either round nose pliers or wire looping pliers to make your simple wire loops for this project.
Onto your head pin, please place the following beads: 1 large bicone bead, 1 teddy bear bead, 1 small bicone bead.
After the last bead, create a simple wire loop. Trim off excess wire.
Open the loop at the base of your earring hook, the same way you would open a jump ring, and link onto it the loop of the bead segment you just made. Close the loop.
Repeat steps 1 - 3 to make your matching earring. Hugs!
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Try other cute beads at the center of this design for fun variations.
These adorable earrings feature a sweet teddy bear bead by TierraCast with its arms stretched out, ready to give a hug. On either side of the bear are lovely PRESTIGE Crystal beads in a rosy pink color.
Please note we have updated this project using PRESTIGE Crystal bicone beads instead of the beads pictured and a slightly smaller earring hook. You can use either round nose pliers or wire looping pliers to make your simple wire loops for this project.
Onto your head pin, please place the following beads: 1 large bicone bead, 1 teddy bear bead, 1 small bicone bead.
After the last bead, create a simple wire loop. Trim off excess wire.
Open the loop at the base of your earring hook, the same way you would open a jump ring, and link onto it the loop of the bead segment you just made. Close the loop.
Repeat steps 1 - 3 to make your matching earring. Hugs!
Try other cute beads at the center of this design for fun variations.