Get creative in your jewelry style with PRESTIGE crystals!
Add a Smoked Amber bicone, a Light Amber faceted round, a Golden Topaz bicone, a Light Amber round, and a Smoked Amber bicone to an eye pin. Make a simple loop at the top of the beads. Repeat twice for a total of three beaded links.
Use the Artbeads Designer Wire to make a messy wrapped loop at the top of a pear-shaped pendant. Repeat for a total of two dangles.
Open the loop at one end of a beaded link and attach a messy wrapped pendant. Close the loop. Add the other end of the beaded link to a leverback earring. Repeat to make the other earring.
Cut a length of chain approximately 2 ½ inches long. Add one end to one end of the remaining beaded link. Repeat this step and attach the chain to the other end of the same beaded link.
Attach a clasp to one end of the bracelet using a jump ring. Attach a jump ring to the other end of the bracelet.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Get creative in your jewelry style with PRESTIGE crystals!
Add a Smoked Amber bicone, a Light Amber faceted round, a Golden Topaz bicone, a Light Amber round, and a Smoked Amber bicone to an eye pin. Make a simple loop at the top of the beads. Repeat twice for a total of three beaded links.
Use the Artbeads Designer Wire to make a messy wrapped loop at the top of a pear-shaped pendant. Repeat for a total of two dangles.
Open the loop at one end of a beaded link and attach a messy wrapped pendant. Close the loop. Add the other end of the beaded link to a leverback earring. Repeat to make the other earring.
Cut a length of chain approximately 2 ½ inches long. Add one end to one end of the remaining beaded link. Repeat this step and attach the chain to the other end of the same beaded link.
Attach a clasp to one end of the bracelet using a jump ring. Attach a jump ring to the other end of the bracelet.