Dakota Stones gemstones and a Gardanne Beads enameled pendant are a winning combination in this necklace design.
Cut a length of jewelry wire approximately 20 inches. Slide a crimp tube onto one end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add the following pattern to the wire:
Repeat this pattern 6 times. Then, add 3 gemstone beads and a coiled spacer.
Add the Gardanne Beads pendant using a jump ring.
Make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the end of the necklace, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Dakota Stones gemstones and a Gardanne Beads enameled pendant are a winning combination in this necklace design.
Cut a length of jewelry wire approximately 20 inches. Slide a crimp tube onto one end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add the following pattern to the wire:
Repeat this pattern 6 times. Then, add 3 gemstone beads and a coiled spacer.
Add the Gardanne Beads pendant using a jump ring.
Make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the end of the necklace, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.