The Damyanah Studio focal bead makes this necklace so unique! It features a different expression on each side, so you can change the look depending on your mood.
Cut a length of jewelry wire approximately 20 inches. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add 15 Dakota Stones blood quartz beads to the strand. Then, add the following pattern:
Repeat this pattern, leaving off the last 3 blood quartz beads.
Add a TierraCast gold spiral bead, the Damyanah Studio face design bead, and a gold spiral bead to the wire. Then, make a mirror image of the entire bead pattern on the other side of this segment.
Add a crimp tube to the end of the necklace, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
The Damyanah Studio focal bead makes this necklace so unique! It features a different expression on each side, so you can change the look depending on your mood.
Cut a length of jewelry wire approximately 20 inches. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add 15 Dakota Stones blood quartz beads to the strand. Then, add the following pattern:
Repeat this pattern, leaving off the last 3 blood quartz beads.
Add a TierraCast gold spiral bead, the Damyanah Studio face design bead, and a gold spiral bead to the wire. Then, make a mirror image of the entire bead pattern on the other side of this segment.
Add a crimp tube to the end of the necklace, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.