Add a bit of whimsy to your wardrobe with these fetching dragonfly earrings. The long earrings are capped off with a dazzling PRESTIGE Crystal pear-shaped pendant in vibrant Citrus Green.
You can use round nose pliers or wire looping pliers to make your simple wire loops for this project. Place the following beads onto an eye pin: 3mm bicone, 3mm pearl, 4mm round bead,4mm pearl, 4mm round bead, dragonfly wings, 3mm pearl. After the last bead, create a simple wire loop. Trim off any excess wire.
Open a jump ring and link onto it the 16mm pear-shaped pendant. Also link onto the jump ring the loop at the base of your dragonfly wing/bead segment. Close the jump ring.
Open the loop at the base of your earring hook, the same way you would open a jump ring, and link the top loop of the dragonfly wing/bead segment onto it. Close the loop back up.
Repeat steps 1 - 3 to make your matching earring. Enjoy!
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Add a bit of whimsy to your wardrobe with these fetching dragonfly earrings. The long earrings are capped off with a dazzling PRESTIGE Crystal pear-shaped pendant in vibrant Citrus Green.
You can use round nose pliers or wire looping pliers to make your simple wire loops for this project. Place the following beads onto an eye pin: 3mm bicone, 3mm pearl, 4mm round bead,4mm pearl, 4mm round bead, dragonfly wings, 3mm pearl. After the last bead, create a simple wire loop. Trim off any excess wire.
Open a jump ring and link onto it the 16mm pear-shaped pendant. Also link onto the jump ring the loop at the base of your dragonfly wing/bead segment. Close the jump ring.
Open the loop at the base of your earring hook, the same way you would open a jump ring, and link the top loop of the dragonfly wing/bead segment onto it. Close the loop back up.
Repeat steps 1 - 3 to make your matching earring. Enjoy!
