Cut a length of 4mm antique silver-plated rolo chain approximately 11 inches long. Repeat for two strands of chain. Attach one piece to one end of the 3.5x5.5-inch satin rhodium-plated brass crescent silver moon pendant using a 5mm antique silver-plated 18 gauge open jump ring. Attach the other piece of chain to the other end of the pendant using a 5mm jump ring.
Attach half of the JBB antique silver-plated pewter heart shaped leaf toggle clasp set to each end of the necklace using a 6mm antique silver-plated 18 gauge open jump ring.
Cut a length of jewelry wire approximately 12 inches long. Slide a sterling silver 2x2mm crimp tube onto one end and bring the end of the wire through a jump ring attached to one half of the toggle clasp and then back through the crimp tube.
String on a random pattern of seven Hill Tribe silver small rolled beads and 18 Dakota Stones multi-colored tourmaline 8x10mm tumble nugget beads, making sure to start and end the strand with a Hill Tribe bead. Then, slide on a crimp tube, and bring the wire through the loop on one end of the 46mm matte silver-plated pewter marquis pendant and then go back through the crimp tube. Crimp in place and add a sterling silver 3mm crimp cover to the tube.
Add all available items to your cart at once or edit the quantities
Nice choice! All or most of the products needed for this project are shown
below with quantities. Sometimes we sell out of components and aren’t able to order more from
the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up
the design and make it yours by substituting similar products or altering the entire color
scheme—it’s up to you!