With an Artbeads Designer Blend in the perfect color palette, you can create a fabulous jewelry set just like this one. Cynthia used the Icicle Designer Blend to add frosty colors to her necklace and bracelet. With a mix of bead caps, she also added texture and detail to her pieces. Find your favorite Designer Blend to make this look all your own.
Cut a length of jewelry wire approximately 11 inches. Slide a sterling silver 2x2mm crimp tube onto the end, followed by half of the 8mm silver-plated round magnetic clasp. Bring your wire back through the crimp tube and crimp in place. Hide the crimp with a sterling silver 3mm crimp cover.
Repeat this pattern four times or until your bracelet is the desired length. Then, add one more pearl to the strand.
For the following bead patterns, string the patterns onto a 2-inch 20 gauge sterling silver head pin and make a wrapped loop at the top of the beads:
Cut a length of jewelry wire approximately eight inches long. Slide a crimp tube onto one end, followed by the end of a 6 1/4-inch length of 5x4.5mm silver-plated flat cable chain. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
With an Artbeads Designer Blend in the perfect color palette, you can create a fabulous jewelry set just like this one. Cynthia used the Icicle Designer Blend to add frosty colors to her necklace and bracelet. With a mix of bead caps, she also added texture and detail to her pieces. Find your favorite Designer Blend to make this look all your own.
Cut a length of jewelry wire approximately 11 inches. Slide a sterling silver 2x2mm crimp tube onto the end, followed by half of the 8mm silver-plated round magnetic clasp. Bring your wire back through the crimp tube and crimp in place. Hide the crimp with a sterling silver 3mm crimp cover.
Repeat this pattern four times or until your bracelet is the desired length. Then, add one more pearl to the strand.
For the following bead patterns, string the patterns onto a 2-inch 20 gauge sterling silver head pin and make a wrapped loop at the top of the beads:
Cut a length of jewelry wire approximately eight inches long. Slide a crimp tube onto one end, followed by the end of a 6 1/4-inch length of 5x4.5mm silver-plated flat cable chain. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
