How to Use a Crimp Cover

Applying a Crimp Cover to a Crimp

Skill LevelBeginner

TechniqueSimple Stringing

Time1-3 Hours

Hide crimps in a professional way with crimp covers. author signature

Give your designs a simple touch of professional beauty using crimp covers. Reminiscent of a small seamed bead, crimp covers are an easy way to class up jewelry designs and prevent snagging your necklace or bracelet on fabric.

Step-by-Step Instructions Expand All Steps

Crimp covers are open on one side allowing them to slip over the crimp tube.

Using a Crimp Cover Step 1

Leave a small amount of slack between the crimp tube and the clasp so that the crimp cover can fit nicely over the crimp tube without interfering with the clasp or jump ring.

Using a Crimp Cover Step 2

You may need to use chain nose pliers to open the crimp cover. Do this by inserting the tip of the pliers into the crimp cover, and slowly open the pliers. Open it just enough so that it will fit over your crimp tube.

Using a Crimp Cover Step 3

Slide the crimp cover over the crimp tube so that the crimp tube is inside the crimp cover.

Using a Crimp Cover Step 4

You can use just about any pliers you want to close the cover; however I like to use the mighty crimper tool. You can use whatever is easiest for you. Place the jaws of the mighty crimper, chain nose, or flat nose pliers around the crimp cover and start squeezing gently. Because the crimp covers are small, it can be tricky to grip them with the mighty crimper at first, so you might try closing the cover part way with flat or chain nose pliers and then switching to the mighty crimper. While you are doing this step you should also watch to make sure that the crimp cover is not closing lopsidedly. If it is, you can correct it by moving your tool to squeeze it a little in the opposite direction. Finish closing the cover by using the front part of the mighty crimpers to squeeze it shut while keeping the crimp cover round.

Using a Crimp Cover Step 5

There you go. You now have what looks like a 3mm seamed bead.

Using a Crimp Cover Step 6

PRINT THIS PAGE

Add all available items to your cart at once or edit the quantities below. Any items with quantities lower than stated minimums will default to the minimum in your cart.

Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!

Sterling Silver 2 x 2mm Crimp Tube Bead - Min Qty 10

Code SS-CRM2

$0.17

Qty:

Add to Cart

Sterling Silver 3mm Crimp Cover - Min Qty 4

Code SS-CCOV01

$0.34

Qty:

Add to Cart

Bead Crimper Tool

Code TOOL-100

$15.79

Qty:

Add to Cart

Chain Nose Pliers

Code TOOL-106

$8.49

Qty:

Add to Cart

Clearance - Was $9.59 - Nipper Tool

Code TOOL-101

$6.46

$9.59

Qty:

Add to Cart