Cynthia started with one of our lush Artbeads Designer Seed Bead Blends and created a fun necklace and earring set that really stands out. Becky challenged Cynthia on Facebook Live with these components to make a piece of jewelry and Cynthia created all of these pieces. The colors were so inspiring, she couldn't stop You can watch Cynthia make these jewelry designs here.
Cut a length of jewelry wire approximately 12 inches long. Slide a 14K/20 gold-filled 2x2mm crimp tube onto one end of the necklace, followed by a 14K/20 gold-filled 5mm 20-5 gauge open round jump ring attached to one side of the 46mm satin gold-plated pewter Marquis pendant. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the TierraCast gold-plated pewter bar and ring clasp set. Bring the wire back through the crimp tube and crimp in place.
Slide a 4mm Bicone in Crystal Paradise Shine onto a gold-filled 025 2-inch eye pin, followed by a TierraCast silver antique 5mm leaf bead cap, a Copper bicone, a bead cap, and a 4mm bicone. Make a wrapped loop at the top of the beads.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Cynthia started with one of our lush Artbeads Designer Seed Bead Blends and created a fun necklace and earring set that really stands out. Becky challenged Cynthia on Facebook Live with these components to make a piece of jewelry and Cynthia created all of these pieces. The colors were so inspiring, she couldn't stop You can watch Cynthia make these jewelry designs here.
Cut a length of jewelry wire approximately 12 inches long. Slide a 14K/20 gold-filled 2x2mm crimp tube onto one end of the necklace, followed by a 14K/20 gold-filled 5mm 20-5 gauge open round jump ring attached to one side of the 46mm satin gold-plated pewter Marquis pendant. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the TierraCast gold-plated pewter bar and ring clasp set. Bring the wire back through the crimp tube and crimp in place.
Slide a 4mm Bicone in Crystal Paradise Shine onto a gold-filled 025 2-inch eye pin, followed by a TierraCast silver antique 5mm leaf bead cap, a Copper bicone, a bead cap, and a 4mm bicone. Make a wrapped loop at the top of the beads.
