Turquoise and gold make a beautiful match in these layered necklaces. Cynthia used crescent pendants to create dangling style with feather charms, crystal pearls, and CzechMates dagger beads. The result is an exotic, bohemian look that's sure to stand out. You can find more globally-influenced jewelry ideas in this Artbeads Cafe episode.
Slide a 6mm round pearl in Jade onto a gold-filled 2-inch head pin, followed by a TierraCast antique gold Jasmine bead cap. Attach it to the second loop from the end of the satin Hamilton gold-plated pewter small elegant crescent pendant by make a wrapped loop at the top of the beads. Repeat this step on the fifth loop over, then the sixth loop over from that, then the fifth loop over from that.
Cut a length of 2.5x3.5mm satin Hamilton gold-plated square wire cable chain approximately 1 1/2 inches long. Attach a CzechMates glass 6mm opaque turquoise with Picasso two-hole dagger bead to the end of the chain using a 14K/20 gold-filled 8mm 20.5 gauge open round jump ring. Repeat nine times for a total of ten dangles.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Turquoise and gold make a beautiful match in these layered necklaces. Cynthia used crescent pendants to create dangling style with feather charms, crystal pearls, and CzechMates dagger beads. The result is an exotic, bohemian look that's sure to stand out. You can find more globally-influenced jewelry ideas in this Artbeads Cafe episode.
Slide a 6mm round pearl in Jade onto a gold-filled 2-inch head pin, followed by a TierraCast antique gold Jasmine bead cap. Attach it to the second loop from the end of the satin Hamilton gold-plated pewter small elegant crescent pendant by make a wrapped loop at the top of the beads. Repeat this step on the fifth loop over, then the sixth loop over from that, then the fifth loop over from that.
Cut a length of 2.5x3.5mm satin Hamilton gold-plated square wire cable chain approximately 1 1/2 inches long. Attach a CzechMates glass 6mm opaque turquoise with Picasso two-hole dagger bead to the end of the chain using a 14K/20 gold-filled 8mm 20.5 gauge open round jump ring. Repeat nine times for a total of ten dangles.