Bicone Bangle Bracelet

Wire-Wrapped Bangle featuring Crystal Lane DIY Designer Bicone Bead Strand

Skill LevelBeginner

TechniqueWire-Working

Time1-3 Hours

Approximate Size7 Inches

The bicone bead strand I used in this bracelet makes it easy to design beautiful jewelry! author signature

You can see Becky create this bracelet in our video!

Step-by-Step Instructions Expand All Steps

To make this bracelet, cut a length of wire approximately 2-3 feet long. Coil the end of the wire around the top wire of the bangle. Add three bicones and wrap the wire around the bottom wire of the bangle. Continue until you have added the desired amount of bicones. Coil the end of the wire around one wire of the bangle and trim.

Note: Please make sure to double check our list of components with what's actually in stock on the supplies tab. We've also added alternate supply codes to try if the original ones are not in stock.
Silver-Plated Brass Double-Wire Bangle Bracelet (BRAC0217, qty 1) (Or, try S-0301)
24-Gauge Silver Tarnish-Resistant Artistic Wire, 10-Yard Spool (AWR24SVR10, qty 1) (Or, try AWR24SVR15)
Crystal Lane DIY Designer Glass Bicone Purple and Blue Mix Four 7-inch 4mm Bead Strands (BEADS8879, qty 1) (Or, try R1826)

PRINT THIS PAGE

Add all available items to your cart at once or edit the quantities below. Any items with quantities lower than stated minimums will default to the minimum in your cart.

Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!