Dakota Stones gemstones are a perfect match for Artbeads Sterling Silver.
Add an Iridescent Dreamy Rose pearl to a head pin. Make a simple loop at the top of the bead. Attach this dangle to the inside center loop of the Artbeads sterling silver pendant using a 4.20mm jump ring.
Cut a length of jewelry wire approximately 22 inches. Slide a crimp tube onto the end of the wire, followed by a 5.95mm jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern twice and then add 5 African opal beads.
Slide the pendant onto the wire and then make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the end of the necklace, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Dakota Stones gemstones are a perfect match for Artbeads Sterling Silver.
Add an Iridescent Dreamy Rose pearl to a head pin. Make a simple loop at the top of the bead. Attach this dangle to the inside center loop of the Artbeads sterling silver pendant using a 4.20mm jump ring.
Cut a length of jewelry wire approximately 22 inches. Slide a crimp tube onto the end of the wire, followed by a 5.95mm jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Add the following pattern to the wire:
Repeat this pattern twice and then add 5 African opal beads.
Slide the pendant onto the wire and then make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the end of the necklace, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
