This necklace is a beautiful combination of delicious chocolate colors and features PRESTIGE Crystals, Dakota Stones gemstones, and an Artbeads Designer Seed Bead Blend.
Add a fire-polished bead, a Tiger Eye bead, and a 6mm Smoke Topaz bicone to a head pin. Make a simple loop at the top of the beads.
Add a 3mm Smoke Topaz bicone, a 5mm Light Colorado Topaz Shimmer bicone, a seed bead, a 6mm pearl, a seed bead, a 5mm bicone, and a 3mm bicone to an eye pin. Attach the eye pin to the bail by making a wrapped loop at the top of the beads. Attach your beaded dangle from the previous step to the bottom of the eye pin.
Cut a length of jewelry wire approximately 14 inches long. Add the bail to the center of the wire. Then, add the following pattern to one side of the bail:
Add a 6mm Light Colorado Topaz Shimmer bicone to the wire and then make a mirror image of the bead pattern from the previous step on the other side of the 6mm Light Colorado Topaz Shimmer bicone.
Add the bead patterns from steps 3 and 4 to the other side of the bail.
Add a crimp tube to one end of your necklace, followed by the last link of a 3-inch length of chain. Bring the wire back through the crimp tube and crimp in place. Repeat on the other end of the necklace.
Add the clasp to each end of the necklace using a jump ring for each.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This necklace is a beautiful combination of delicious chocolate colors and features PRESTIGE Crystals, Dakota Stones gemstones, and an Artbeads Designer Seed Bead Blend.
Add a fire-polished bead, a Tiger Eye bead, and a 6mm Smoke Topaz bicone to a head pin. Make a simple loop at the top of the beads.
Add a 3mm Smoke Topaz bicone, a 5mm Light Colorado Topaz Shimmer bicone, a seed bead, a 6mm pearl, a seed bead, a 5mm bicone, and a 3mm bicone to an eye pin. Attach the eye pin to the bail by making a wrapped loop at the top of the beads. Attach your beaded dangle from the previous step to the bottom of the eye pin.
Cut a length of jewelry wire approximately 14 inches long. Add the bail to the center of the wire. Then, add the following pattern to one side of the bail:
Add a 6mm Light Colorado Topaz Shimmer bicone to the wire and then make a mirror image of the bead pattern from the previous step on the other side of the 6mm Light Colorado Topaz Shimmer bicone.
Add the bead patterns from steps 3 and 4 to the other side of the bail.
Add a crimp tube to one end of your necklace, followed by the last link of a 3-inch length of chain. Bring the wire back through the crimp tube and crimp in place. Repeat on the other end of the necklace.
Add the clasp to each end of the necklace using a jump ring for each.