Brass embellishments and pendants are fun to layer together for one-of-a-kind focal pieces. This necklace combines a layered brass pendant with Dakota Stones gemstones and Czech glass.
Glue the dragonfly embellishment to the hammered ring pendant using epoxy adhesive and allow to dry.
Cut a length of jewelry wire approximately 20 inches. Slide a crimp tube onto the end of the wire, followed by a 6mm jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add 3 fire-polished beads to the strand and copper spacer. Repeat twice.
Add 3 gemstone beads, a spacer, 3 fire-polished beads, and a spacer to the strand. Repeat two times and then add 3 more gemstone beads.
Add the pendant to the center of the necklace using an 8mm jump ring. Make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Brass embellishments and pendants are fun to layer together for one-of-a-kind focal pieces. This necklace combines a layered brass pendant with Dakota Stones gemstones and Czech glass.
Glue the dragonfly embellishment to the hammered ring pendant using epoxy adhesive and allow to dry.
Cut a length of jewelry wire approximately 20 inches. Slide a crimp tube onto the end of the wire, followed by a 6mm jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add 3 fire-polished beads to the strand and copper spacer. Repeat twice.
Add 3 gemstone beads, a spacer, 3 fire-polished beads, and a spacer to the strand. Repeat two times and then add 3 more gemstone beads.
Add the pendant to the center of the necklace using an 8mm jump ring. Make a mirror image of the bead pattern on the other side of the pendant.
Add a crimp tube to the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.