The colors of Raven's Journey Czech glass beads are so inspiring! The Raven's Journey coin beads in this set made the perfect palette starter, so Jessica paired them with pink and teal beads.
Earrings:
Slide a beaded bead cap, a teal fire-polished bead, and a beaded bead cap onto a head pin. Make a simple loop at the top of the beads.
Open the loop of an ear wire and attach it to the simple loop at the top of your eye pin. Close the loop.
Repeat these steps to make the second earring.
Bracelet:
Cut a length of jewelry wire approximately 10 inches long. Slide a crimp tube onto the end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add the following pattern to the wire:
Repeat the pattern once and then add a teal bead, a hammertone rondelle, a coin bead, a hammertone rondelle, and a milky pink bead.
Add a crimp tube to the end of the bracelet, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
The colors of Raven's Journey Czech glass beads are so inspiring! The Raven's Journey coin beads in this set made the perfect palette starter, so Jessica paired them with pink and teal beads.
Earrings:
Slide a beaded bead cap, a teal fire-polished bead, and a beaded bead cap onto a head pin. Make a simple loop at the top of the beads.
Open the loop of an ear wire and attach it to the simple loop at the top of your eye pin. Close the loop.
Repeat these steps to make the second earring.
Bracelet:
Cut a length of jewelry wire approximately 10 inches long. Slide a crimp tube onto the end, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add the following pattern to the wire:
Repeat the pattern once and then add a teal bead, a hammertone rondelle, a coin bead, a hammertone rondelle, and a milky pink bead.
Add a crimp tube to the end of the bracelet, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
