Show off your spooky side with this statement necklace full of scary skulls!
Cut a length of matte jet black dangling skull chain approximately 13 ½ inches long. Save any skull dangles that fall off of the cut chain link.
Slide a 4mm Hyacinth bicone onto an eye pin, followed by a Jet AB 4mm bicone and a Hyacinth bicone. Make a simple loop at the top of the beads. Open the loop at the bottom of the link and attach one of the fallen skull dangles. Close the loop. Repeat this step 4 times for a total of 5 dangles.
Add a Hyacinth bicone, a Jet AB bicone, and a Hyacinth bicone to an eye pin and make a simple loop. Attach this link to the center of your skull chain using an oval jump ring. Open the bottom loop of the link and attach a 5-link length of chain. Close the loop. Attach one of your skull dangles to the bottom link of the chain.
Cut a 5-link length of skull chain and attach it 3 links over from the center dangle using a jump ring. Attach one of the skull dangles to the bottom link of the 5-link length of skull chain. Repeat this step on the other side of the center dangle.
Attach one of the skull dangles 3 links over from the last dangle added using a jump ring. Repeat on the other side of the necklace.
Attach the trigger clasp to one end of the necklace using a jump ring.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Show off your spooky side with this statement necklace full of scary skulls!
Cut a length of matte jet black dangling skull chain approximately 13 ½ inches long. Save any skull dangles that fall off of the cut chain link.
Slide a 4mm Hyacinth bicone onto an eye pin, followed by a Jet AB 4mm bicone and a Hyacinth bicone. Make a simple loop at the top of the beads. Open the loop at the bottom of the link and attach one of the fallen skull dangles. Close the loop. Repeat this step 4 times for a total of 5 dangles.
Add a Hyacinth bicone, a Jet AB bicone, and a Hyacinth bicone to an eye pin and make a simple loop. Attach this link to the center of your skull chain using an oval jump ring. Open the bottom loop of the link and attach a 5-link length of chain. Close the loop. Attach one of your skull dangles to the bottom link of the chain.
Cut a 5-link length of skull chain and attach it 3 links over from the center dangle using a jump ring. Attach one of the skull dangles to the bottom link of the 5-link length of skull chain. Repeat this step on the other side of the center dangle.
Attach one of the skull dangles 3 links over from the last dangle added using a jump ring. Repeat on the other side of the necklace.
Attach the trigger clasp to one end of the necklace using a jump ring.