Raven's Journey Czech glass colors are paired perfectly with a patina focal in this creative necklace design.
Attach a jump ring to each tip of the patina crescent embellishment. Slide a melon drop bead onto a head pin and make a wrapped loop. Repeat for a total of two dangles. Attach these dangles to the center of the crescent embellishment using a jump ring for each.
Cut a length of jewelry wire approximately 20 inches long. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add 43 seed beads to the wire.
Add the following pattern to the wire:
Repeat this pattern once.
Slide the jump ring on one end of the crescent embellishment onto the wire. Then, add a seed bead, a wild rose, and a seed bead to the wire. Then, bring the wire through the jump ring on the other end of the crescent embellishment.
Make a mirror image of the bead pattern on the other side of the crescent embellishment.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Raven's Journey Czech glass colors are paired perfectly with a patina focal in this creative necklace design.
Attach a jump ring to each tip of the patina crescent embellishment. Slide a melon drop bead onto a head pin and make a wrapped loop. Repeat for a total of two dangles. Attach these dangles to the center of the crescent embellishment using a jump ring for each.
Cut a length of jewelry wire approximately 20 inches long. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add 43 seed beads to the wire.
Add the following pattern to the wire:
Repeat this pattern once.
Slide the jump ring on one end of the crescent embellishment onto the wire. Then, add a seed bead, a wild rose, and a seed bead to the wire. Then, bring the wire through the jump ring on the other end of the crescent embellishment.
Make a mirror image of the bead pattern on the other side of the crescent embellishment.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
