Cobra Coiler Wire Tool

Coil wires with ease using the Cobra Coiler wire tool. This tool comes with a mountable coiler, two mandrels that are 1/8-inch and 1/16-inch in diameter, instructions for use and a carrying case. With this tool, you can make coiled beads, beaded coils and everything in between. All you have to do is secure the Cobra Coiler to your work table, insert and tighten your desired mandrel, slide the wire into one of the slots, hold the wire with one hand and wind the crank with the other. You can also use other mandrels with this tool, from mandrels as thin as a pin to mandrels slightly thicker than 1/4-inch in diameter. Note: For a limited time, the Cobra Coiler will include an extra mandrel. This mandrel is shaped like a triangle, so you can make fun and interesting shapes within your jewelry. This extra mandrel is included with the Cobra Coiler only while supplies last, so make sure to get yours today.