Dakota Stones large-hole gemstones make a beautiful accent to leather in these earrings.
Cut a length of leather approximately 4 inches long. Add a TierraCast end cap to one end using glue and allow to dry.
Add three gemstone beads to the leather. Add another end cap to the other end of the leather using glue and allow to dry.
Add a jump ring to each end of the leather. Then, attach the two jump rings together using a single jump ring to form a hoop. With that final jump ring still open, attach your hoop to the bottom ring of the earring component. Close the jump ring.
Repeat these steps to make the other earring.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Dakota Stones large-hole gemstones make a beautiful accent to leather in these earrings.
Cut a length of leather approximately 4 inches long. Add a TierraCast end cap to one end using glue and allow to dry.
Add three gemstone beads to the leather. Add another end cap to the other end of the leather using glue and allow to dry.
Add a jump ring to each end of the leather. Then, attach the two jump rings together using a single jump ring to form a hoop. With that final jump ring still open, attach your hoop to the bottom ring of the earring component. Close the jump ring.
Repeat these steps to make the other earring.
