Make these earrings and see why Emerald Cut Pendants are so perfect for making earrings.
Cut a length of Vintaj brass cable chain approximately 2 ½ inches long.
Attach a 12mm Emerald Cut Pendant in Light Colorado Topaz to the last link of chain using a patina finish jump ring. Attach a 9mm Emerald Cut Pendant in Light Colorado Topaz to the same link of chain, one on each side of the center 12mm pendant, using a Vintaj rib cable jump ring for each.
Add a 4mm Bicone in Crystal Luminous Green to a head pin and make a wrapped loop at the top of the bead. Repeat 5 times for a total of six dangles.
Add a 4mm Briolette Bead in Light Colorado Topaz Shimmer 2x to a head pin and make a wrapped loop at the top of the bead. Repeat 5 times for a total of six dangles.
Attach your dangles to the chain links above the Emerald cut pendants, using an oval jump ring for each dangle. Hold up the chain as you add the dangles to see how they fall on the chain, and adjust as you go.
Repeat these steps to make the other earring.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Make these earrings and see why Emerald Cut Pendants are so perfect for making earrings.
Cut a length of Vintaj brass cable chain approximately 2 ½ inches long.
Attach a 12mm Emerald Cut Pendant in Light Colorado Topaz to the last link of chain using a patina finish jump ring. Attach a 9mm Emerald Cut Pendant in Light Colorado Topaz to the same link of chain, one on each side of the center 12mm pendant, using a Vintaj rib cable jump ring for each.
Add a 4mm Bicone in Crystal Luminous Green to a head pin and make a wrapped loop at the top of the bead. Repeat 5 times for a total of six dangles.
Add a 4mm Briolette Bead in Light Colorado Topaz Shimmer 2x to a head pin and make a wrapped loop at the top of the bead. Repeat 5 times for a total of six dangles.
Attach your dangles to the chain links above the Emerald cut pendants, using an oval jump ring for each dangle. Hold up the chain as you add the dangles to see how they fall on the chain, and adjust as you go.
Repeat these steps to make the other earring.