This jewelry set was made with our exclusive Czech glass sampler tin in pink, available only in our Artbeads Rewards Center. The tin is the perfect way to get familiar with various Czech glass shapes, like bell flowers, Finial beads, Teacups, and more. All of the beads featured in these projects came from just one tin, and there are even more beads included to inspire your next designs. Redeem the rewards tin with our link above or take a look at our Perfect Product Pairings for similar beads to use in the design.
Use the Beadalon Tassel maker to make a tassel with the TOHO Amiet beading thread in Salmon. Use the large round jump ring from the tin for the top of the tassel. Coil 22 gauge Yellow Gold Artbeads Designer Wire a few times around the top of the tassel to secure it in place. Trim the ends of the tassel to your liking.
Cut a length of Designer Wire approximately two inches long. Glue a green Finial bead from the tin onto the end of the wire using 5-minute two-part epoxy adhesive. Repeat two times for a total of three green head pins. Allow to dry.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This jewelry set was made with our exclusive Czech glass sampler tin in pink, available only in our Artbeads Rewards Center. The tin is the perfect way to get familiar with various Czech glass shapes, like bell flowers, Finial beads, Teacups, and more. All of the beads featured in these projects came from just one tin, and there are even more beads included to inspire your next designs. Redeem the rewards tin with our link above or take a look at our Perfect Product Pairings for similar beads to use in the design.
Use the Beadalon Tassel maker to make a tassel with the TOHO Amiet beading thread in Salmon. Use the large round jump ring from the tin for the top of the tassel. Coil 22 gauge Yellow Gold Artbeads Designer Wire a few times around the top of the tassel to secure it in place. Trim the ends of the tassel to your liking.
Cut a length of Designer Wire approximately two inches long. Glue a green Finial bead from the tin onto the end of the wire using 5-minute two-part epoxy adhesive. Repeat two times for a total of three green head pins. Allow to dry.
