Decadent and delicious colors make this bracelet a rich accent for any style. The perfect color palette is provided by crystal bicones and pearls from an Artbeads Designer Blend. Cynthia simply paired them with TOHO Demi round seed beads and a copper clasp for a quick yet stunning multi-strand look.
Cut a length of jewelry wire approximately 10 inches long. Slide a 14K/20 gold-filled 2x2mm crimp tube onto the end, followed by a 6mm antique copper 20 gauge open jump ring attached to half of the JBB antique copper-plated brass leaves with flowers toggle clasp set. Bring the wire back through the crimp tube and crimp in place.
Repeat eight times or until your strand is the desired length. Make sure to leave off the last pearl when completing your strand. Add a crimp tube to the end of the strand, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Repeat this pattern 23 times or until the strand is the desired length. Make sure to add a pearl and a Demi round to the end when completing your strand. Add a crimp tube to the end of the strand. Loop the end around the jump ring on the other end of the bracelet and back through the crimp tube. Crimp in place.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Decadent and delicious colors make this bracelet a rich accent for any style. The perfect color palette is provided by crystal bicones and pearls from an Artbeads Designer Blend. Cynthia simply paired them with TOHO Demi round seed beads and a copper clasp for a quick yet stunning multi-strand look.
Cut a length of jewelry wire approximately 10 inches long. Slide a 14K/20 gold-filled 2x2mm crimp tube onto the end, followed by a 6mm antique copper 20 gauge open jump ring attached to half of the JBB antique copper-plated brass leaves with flowers toggle clasp set. Bring the wire back through the crimp tube and crimp in place.
Repeat eight times or until your strand is the desired length. Make sure to leave off the last pearl when completing your strand. Add a crimp tube to the end of the strand, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
Repeat this pattern 23 times or until the strand is the desired length. Make sure to add a pearl and a Demi round to the end when completing your strand. Add a crimp tube to the end of the strand. Loop the end around the jump ring on the other end of the bracelet and back through the crimp tube. Crimp in place.