Dakota Stones druzy beads and crystals are the perfect match for the Patricia Healey pendant at the center of this necklace.
Cut a length of jewelry wire approximately 17 inches. Slide a crimp tube onto the end of the wire, followed by an oval jump ring. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add a Crystal Iridescent Green bicone and a Light Topaz faceted round to the wire and then add the following pattern :
Repeat this pattern four times, leaving off the last bicone.
Add the Patricia Healey pendant to the wire. Make a mirror image of the bead pattern on the other side of the pendant.
Slide a crimp tube onto the end of the wire followed by an oval jump ring. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Attach half of the clasp to the jump ring at one end of the necklace using two more jump rings linked together. Repeat on the other side of the necklace.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Dakota Stones druzy beads and crystals are the perfect match for the Patricia Healey pendant at the center of this necklace.
Cut a length of jewelry wire approximately 17 inches. Slide a crimp tube onto the end of the wire, followed by an oval jump ring. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Crimp Cover Tutorial
Add a Crystal Iridescent Green bicone and a Light Topaz faceted round to the wire and then add the following pattern :
Repeat this pattern four times, leaving off the last bicone.
Add the Patricia Healey pendant to the wire. Make a mirror image of the bead pattern on the other side of the pendant.
Slide a crimp tube onto the end of the wire followed by an oval jump ring. Bring the wire back through the crimp tube and crimp in place. Hide the crimp with a crimp cover.
Attach half of the clasp to the jump ring at one end of the necklace using two more jump rings linked together. Repeat on the other side of the necklace.
