Make a bracelet that was featured in our Artbeads Boot Camp Classes at Bead Fest!
Cut a length of 24 gauge wire 3-4 feet long.
Coil the end of the wire around the bangle. Make about 3 coils to start.
Add three seed beads to the wire and then wrap around the bangle so that the seed bead faces the outside of the bangle. Make 2-3 plain or empty coils after the beads.
Add a melon bead to the wire and then wrap around the bangle so that the seed bead faces the outside of the bangle. Make 2-3 plain or empty coils after the beads.
Repeat steps 3-4 around the length of the bangle. Finish the wire by coiling and trim with cutters.
Add a moon charm to the bangle using a jump ring.
Note: Please make sure to double check our list of components with what's actually in stock on the supplies tab.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
Make a bracelet that was featured in our Artbeads Boot Camp Classes at Bead Fest!
Cut a length of 24 gauge wire 3-4 feet long.
Coil the end of the wire around the bangle. Make about 3 coils to start.
Add three seed beads to the wire and then wrap around the bangle so that the seed bead faces the outside of the bangle. Make 2-3 plain or empty coils after the beads.
Add a melon bead to the wire and then wrap around the bangle so that the seed bead faces the outside of the bangle. Make 2-3 plain or empty coils after the beads.
Repeat steps 3-4 around the length of the bangle. Finish the wire by coiling and trim with cutters.
Add a moon charm to the bangle using a jump ring.
Note: Please make sure to double check our list of components with what's actually in stock on the supplies tab.
