The pendants in this set make a beautiful complement to the pearls and beads used throughout the pieces. Cynthia finished the necklace with chain to keep the focus on the center and to echo the metallic silver shine on the top of the pendant. You can watch Cynthia make this set and other jewelry pieces in this Facebook Live Design Challenge video.
Cut a length of jewelry wire approximately 7 inches long. Slide a silver-plated 2x2mm crimp tube onto the end of the wire, followed by the last link of a 6 ½-inch length of 050 sterling silver long cable chain. Bring the wire back through the crimp tube and crimp in place.
Add a 22mm metallic cap pear-shaped pendant in Light Rose Light Chrome to the wire using a JBB antique sterling silver dot design pinch bail. Close the prongs of the pinch bail down into the stringing hole of the pendant and then slide onto the wire. Make a mirror image of the bead pattern on the other side of the pendant.
Opening and Closing Jump Rings Video
,Add a briolette to a sterling silver 22 gauge 3-inch bead cap eye pin, followed by a cube bead and a briolette. Make a wrapped loop at the top of the beads.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
The pendants in this set make a beautiful complement to the pearls and beads used throughout the pieces. Cynthia finished the necklace with chain to keep the focus on the center and to echo the metallic silver shine on the top of the pendant. You can watch Cynthia make this set and other jewelry pieces in this Facebook Live Design Challenge video.
Cut a length of jewelry wire approximately 7 inches long. Slide a silver-plated 2x2mm crimp tube onto the end of the wire, followed by the last link of a 6 ½-inch length of 050 sterling silver long cable chain. Bring the wire back through the crimp tube and crimp in place.
Add a 22mm metallic cap pear-shaped pendant in Light Rose Light Chrome to the wire using a JBB antique sterling silver dot design pinch bail. Close the prongs of the pinch bail down into the stringing hole of the pendant and then slide onto the wire. Make a mirror image of the bead pattern on the other side of the pendant.
Opening and Closing Jump Rings Video
,Add a briolette to a sterling silver 22 gauge 3-inch bead cap eye pin, followed by a cube bead and a briolette. Make a wrapped loop at the top of the beads.