This bracelet and earrings set is inspired by crystal colors that represent the Grand Canyon.
For the bracelet, cut a length of jewelry wire approximately 11 inches. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the toggle clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add the following pattern to the wire:
Repeat this pattern twice, then add 3 Crystal Copper bicones and an organic metal bead.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
For the earrings, Slide 3 Montana Sapphire bicones onto a head pin. Make a wrapped loop at the top of the beads.
Add 3 Smoked Topaz bicones to an eye pin. Make a wrapped loop at the top of the beads. Open the loop at the bottom of the eye pin and attach to the wrapped loop at the top of your Montana Sapphire dangle.
Add 3 Crystal Copper bicones to an eye pinand make a wrapped loop at the top of the beads. Open the loop at the bottom of the eye pin and attach it to the wrapped loop at the top of the Smoked Topaz link.
Add a jump ring to the hole of the Nunn Design elongated diamond primitive tag penant. Then, layer the beaded dangle you created in front of the pendant by attaching it to the jump ring using another jump ring.
Attach an ear wire to the top of the pendant using another jump ring.
Repeat these steps to make the other earring.
Nice choice! All or most of the products needed for this project are shown below with quantities. Sometimes we sell out of components and aren’t able to order more from the manufacturer (we know, it is very disappointing to us, too). Use the opportunity to mix up the design and make it yours by substituting similar products or altering the entire color scheme—it’s up to you!
This bracelet and earrings set is inspired by crystal colors that represent the Grand Canyon.
For the bracelet, cut a length of jewelry wire approximately 11 inches. Slide a crimp tube onto the end of the wire, followed by a jump ring attached to half of the toggle clasp. Bring the wire back through the crimp tube and crimp in place.
Opening and Closing Jump Rings Video
Crimp Tool Tutorial
Crimp Tube Video Tutorial
Add the following pattern to the wire:
Repeat this pattern twice, then add 3 Crystal Copper bicones and an organic metal bead.
Slide a crimp tube onto the end of the wire, followed by a jump ring attached to the other half of the clasp. Bring the wire back through the crimp tube and crimp in place.
For the earrings, Slide 3 Montana Sapphire bicones onto a head pin. Make a wrapped loop at the top of the beads.
Add 3 Smoked Topaz bicones to an eye pin. Make a wrapped loop at the top of the beads. Open the loop at the bottom of the eye pin and attach to the wrapped loop at the top of your Montana Sapphire dangle.
Add 3 Crystal Copper bicones to an eye pinand make a wrapped loop at the top of the beads. Open the loop at the bottom of the eye pin and attach it to the wrapped loop at the top of the Smoked Topaz link.
Add a jump ring to the hole of the Nunn Design elongated diamond primitive tag penant. Then, layer the beaded dangle you created in front of the pendant by attaching it to the jump ring using another jump ring.
Attach an ear wire to the top of the pendant using another jump ring.
Repeat these steps to make the other earring.